Just two days ago, I wrote about how you might go about fixing squeaks in carpeted and hardwood floors, a common, pestering and often ignored problem in the home. A friend of mine was good enough to point out that I left out a few other types of flooring, the most prominent of which being tiled floors. Damage to tiles is often done with the most minor and ignorable of actions: Erosion from constant wear, scrapes from furniture and other harsh edges, dirt rubbed and ground in, dropped items both weighty and sharp, and certain chemical cleaners. Naturally, replacing damaged tiles is something that comes up frequently, especially in kitchen floors and bathrooms. You’ll need the following items:
· Colored Masking Tape
· Replacement Tiles
· Nails & Hammer
· Chisel
· Trowel
· Grout & Grout Float
· Sponge
· Set Mortar
· Gloves (optional)
Begin by taping off the surrounding area of the tiles with the masking tape, being sure to cut the tape before the grout, as that will be getting replaced as well. So, the damaged tile(s) and the grout directly surrounding it should be taped off. Take a nail and hit it into the center of the damaged tile(s) to shatter the tile and make it easier to pick up in pieces. Use a chisel to clear out every last trace of the old tile, so that you can lay the new tile on an even surface. (You might want to use gloves while picking up the small shards to make sure you don’t get cut.)
Once the space is clear, take your replacement tile(s) and put a very thin layer of thin set mortar on the bottom of the tile with a trowel. Make sure it is just enough to set the tile in place, as you don’t want to have any mortar squeeze up around the sides of the tile. Let it dry (six to eight hours, to be safe) and then lay down some grout using a grout float to make sure it gets deep into the surrounding area. When you’re done, use a sponge to clean up any unwanted grout on the tile(s). Let the grout dry and pull up the tape to take a look at your brand new tile(s). That’s enough about flooring for now.
